Welcome to CHINAPLAS 2018 Shanghai international rubber and plastic exhibition with HVR MAG

In April 24-27, 2018, CHINAPLAS 2018 Shanghai international rubber and plastic exhibition will be held in Shanghai Hongqiao national convention and exhibition center. The exhibition area is expected to be over 320,000 square meters with 4,000 exhibitors worldwide.

HVR Magnetics Co,. Ltd is also invice exhibition, and it is located in the 5.1U39 booths. Welcome to visit HVR MAG products.

Our main display products of this exhibition are：Electro Permanent Magnet Quick Mold Change System, Electro Permanent Magnets for Automation, Electro Permanent Magnet for lifting, and all the series of Electro Permanent Magnet Clamping System .

Here are the advantages of our Electro permanent magnet clamping system :

1. Easy to Install

No need of manual adjustment when the mold is fixed in the tapping holes or T-slot.

2. Safety

Only used electricity in 1-2 seconds of the MAG and DEMAG phase; no need of  electricity during the working,which enables it still in the state of working even power off and would not cause any damage to operators; equipped with safe devices like detection, temperature detection and location detection.

3. High Efficiency

In general, it only takes 3min to change a mold and the time for changing an oversize mold is decreased from 2 hours to 10 min.

4. Maintenance Free

No extra costs on screws, nuts, clamps and other instruments, no distortion to the mold.

5. Simple Operation

Simple and clear operation penal enables any operator with no operating skills can operate independently in one minute.

6. Strong Magnetic Force and Safe Devices

Magnetic force can reach 16kg/c㎡ and will not decrease as time goes.